cardiogugl.blogg.se

Smartreporter r77.30 to r80.10
Smartreporter r77.30 to r80.10












R1(config-router)#no passive-interface GigabitEthernet0/0Ĭ. R1(config-if)#passive-interface GigabitEthernet0/0.ī. Which command do you enter to filter only routing updates that are sent through interface GigabitEthernet0/0?Ī. They use only the OSPF cost from redistribution. They use only the OSPF cost to the ASBR.Į. They use the OSPF cost from redistribution and the OSPF cost to the ASBR.ĭ. They are preferred over interarea routes.ī. Which two statements about OSPF E1 routes are true? (Choose two.)Ī. Which two technologies can encapsulate an IPv6 payload in an IPv4 packet for transmission across a network? (Choose two.) EIGRP route advertisement is configured under the ipv6 router eigrp configuration. EIGRP route advertisement is configured under the interface configuration.į. EIGRP neighbor relationships can be formed only on the configured IPv6 address.ĭ. EIGRP neighbor relationships are formed using the link-local address.ī. Which three statements about IPv6 EIGRP are true? (Choose three.)Ī. If the IGP in AS65000 is RIPv2, which networks are displayed when you enter show ip route on router R2?Ī.

smartreporter r77.30 to r80.10

Which Cisco Express Forwarding table or tables hold forwarding information?Ĭisco Express Forwarding uses adjacency tables to prepend Layer 2 addressing information to packets. It operates when the line is up by the line protocol is down.Į. It operates on Frame Relay DCE interfaces.ĭ. It operates on Frame Relay DTE interfaces.Ĭ.

smartreporter r77.30 to r80.10

It requires the LMI type to be explicitly configured.ī. Which two statements about Frame Relay LMI autosense are true on a Router? (Choose two.)Ī. What is the default maximum segment size for TCP traffic? Which two commands must you configure in the calling router to support the PPPoE client? (Choose two.) It generates an ICMP unreachable message for the frame. A creates a null route for the destination and adds it to the route table.ĭ. It generates a TCP Fin bit and sends it to the source.Ĭ. It scans the rest of the ACL for a permit entry matching the destination.ī. When a packet is denied by an IPv6 traffic filter, which additional action does the device perform?Ī.














Smartreporter r77.30 to r80.10